V2000-c Rfid Access Control User Manual 〈1080p〉

The V2000-C RFID Access Control is a standalone 125KHz EM card system supporting up to 1,000 users, offering adjustable door open times, and featuring a rugged plastic, non-waterproof design. While praised for its fast response time and versatility, users often report complex programming procedures. For official setup instructions, you can download the V2000-C User Manual directly from Obohands. programming NTIL V2000-c+ RFID Access Keypad - JustAnswer

Common Settings

  • Access Mode: Card only / Card + PIN / PIN only (if keypad present).
  • Anti-passback: Enable to prevent card reuse without exit (if supported).
  • Door Open Alarm Time: Time before alarm when door left open (e.g., 30s).
  • Tamper Alarm: Enable/disable tamper detection output.
  • Wiegand Output: Reader can output Wiegand 26/34 format; configure bit length and facility code.

If you forget the master code, power off the unit, short the specific jumper (often J2 or S16), then power it back on. The device will typically beep and flash to confirm initialization. Weatherproofing: V2000-c Rfid Access Control User Manual

Note: The exact manual may vary slightly by firmware version. The following is a synthesized, practical guide based on standard features of the V2000-C series. The V2000-C RFID Access Control is a standalone

  • Keypad:

    3. Safety & Compliance Warnings

    The manual emphasizes the following:

    V2000-C RFID Access Control User Manual: A Comprehensive Guide Access Mode: Card only / Card + PIN

    Installation Checklist

    • Confirm voltage matches device rating.
    • Mount reader at recommended height (typically 1.2–1.4 m / 48–55 inches).
    • Test card read range and adjust position.
    • Test lock release and door sensor operation.
    • Configure and test alarms and logs.
    • Document admin credentials and store securely.

    Q: The manual says “Wiegand input” – can I connect a fingerprint reader? A: Yes. Any Wiegand 26/34 output device can connect to terminals 10(+), 11(D0), 12(D1), and GND. The V2000-c will treat the fingerprint ID as a card ID.

    • Remonter