Reset Epson L380-l382-l383-l385-l485-l386 Adjustment Program ❲HOT - SECRETS❳

If your Epson printer is flashing red lights and showing a "Service Required" message, you likely need the Adjustment Program. This utility resets the waste ink pad counter, allowing your printer to function again without an expensive trip to the repair shop. Understanding the Epson Waste Ink Pad Error

Resetting the software does not physically clean the ink pads. While the software reset allows you to keep printing, the ink sponges are still physically saturated. Reset Epson L380-l382-l383-l385-l485-l386 Adjustment Program

📎 Final tip

Do NOT upload your printer EEPROM or share your adjustment program dump – each program may be tied to a specific firmware version. If your Epson printer is flashing red lights

Method B: Manual USB Driver Installation

Go to Devices and Printers > Right-click your Epson L380 > Properties > Hardware. Ensure the driver is "USB Printing Support" – not "Generic." While the software reset allows you to keep

🚨 When do you need it?

Your Epson printer will stop working and show:

If your Epson L380, L382, L383, L385, L485, or L386 printer has suddenly stopped working and is flashing red lights, you’ve likely encountered the "Service Required" error. This usually means the internal waste ink pad counter has reached its limit.

To reset the waste ink pad counter on your Epson L380 , L485, or L386 printer, you can use the Epson Adjustment Program (often called a "Resetter"). This process clears the "service required" error that occurs when the printer's internal ink pads are detected as full. Pre-Reset Checklist