How To Reset Sharp Ar-6020 ((link)) -

To reset a Sharp AR-6020, you typically need to access its Service Mode (Simulation Mode). The specific reset procedure depends on whether you are trying to clear a general error code (like H4) or reset the maintenance counter after servicing. 1. Access Simulation Mode

sequence, technicians use simulation codes to reset the maintenance counters, ensuring the "sun" icon for developer replacement or service vanishes after the work is done. A New Password how to reset sharp ar-6020

  1. The Interruption: Locate the main power switch. On the AR-6020, this is typically a rocker switch located on the left side of the machine body, or sometimes behind the front panel depending on your specific region's model variation.
  2. The Pause: Turn the switch to the OFF position.
  3. The Silence: Wait. This is the most important step. Do not simply flick it back on. You must allow the internal capacitors to discharge fully. Wait for at least 30 to 60 seconds.
  4. The Restart: Turn the machine back on. Allow it to go through its warm-up cycle.

1. Soft Reset / Error Clearing (Most Common)

If the machine is locked up, shows a non-fatal error (like "F" codes, misfeed memory, or developer required), use the Simulation 16 method. To reset a Sharp AR-6020, you typically need

To reset a Sharp AR-6020 digital multifunctional system, you must enter the machine's "Simulation Mode" to clear specific error codes or maintenance counters. The exact steps depend on whether you are clearing a general system error or a maintenance light. General System Error Reset (e.g., H2, H4 codes) The Interruption: Locate the main power switch

Restart: Reconnect to the wall, toggle the main power switch ON, and press the power button on the panel to boot. 2. Resetting Maintenance & Error Counters

After replacing parts like the drum or developer, you must reset the internal counters: