Gunnebo Speedstile Fl Installation Manual Verified ❲2027❳
Gunnebo SpeedStile FL Installation Manual: A Comprehensive Guide
Pre-installation — site, survey, and preparation
- Site survey is decisive. A thorough survey records floor flatness, substrate type (concrete, raised floor, timber), nearby utilities, and pedestrian circulation patterns. Measure multiple times: an apparently level slab may have millimeters of deviation that will reveal themselves as binding glass wings or misaligned sensors.
- Foundations and anchors. The SpeedStile FL expects a solid, vibration-free anchor. Concrete of sufficient strength (typically class C25/30 or better) and finished to a specified flatness is standard. Anchor bolts should be set using templates to maintain the exact centerline and skew. If installing on raised floors or tiles, design a backing plate or subframe to distribute loads and prevent movement.
- Environmental considerations. Placement near exterior doors, HVAC diffusers, or direct sunlight can affect sensors and the longevity of seals. Ensure drainage and protection from moisture ingress; humidity and dust require appropriate sealing and, in some environments, additional filters or enclosures for electronics.
- Map in/out readers to the correct lane direction and define statuses for accepted, denied, or pending passages.
- Connect the sensors to the control unit.
- Route cables and connectors according to the manufacturer's instructions.
Floor Quality: The finished floor must be flat and level within ± 5mm. gunnebo speedstile fl installation manual