Gps Tracker Parameter Editor -

A useful feature for a GPS Tracker Parameter Editor is the ability to batch-configure settings across multiple devices simultaneously. This is particularly helpful for fleet managers who need to maintain consistent tracking intervals, power-saving modes, or alert thresholds across many units without individual manual setup.

3.2 By Protocol Support

• Single-brand editors – Designed for one manufacturer’s protocol (e.g., Meitrack, Queclink, Concox).
• Universal editors – Support multiple protocols (e.g., GT06, TK103, AVL) and allow raw command editing.
• Proprietary SDK-based editors – Embedded within a larger fleet platform (e.g., Wialon, GPSWOX).

: Enable "Sleep" or "Deep Sleep" modes. This tells the GPS module to shut down after a period of inactivity, significantly extending battery life. Alert Thresholds : Configure specific triggers for Over-speed alarms Geo-fencing (virtual boundaries), and even sensitivity for vibration/tilt sensors Device Identity : Assign a custom Tracker ID gps tracker parameter editor

| Parameter ID | Name | Typical Values | Description | | :--- | :--- | :--- | :--- | | 1 | APN | internet, telstra.datapack | Access Point Name of local carrier | | 2 | Server IP | 52.14.120.89 | Destination for GPRS data stream | | 3 | Server Port | 7008, 8010 | TCP/UDP listening port | | 4 | Heartbeat Interval | 60, 300, 600 (seconds) | How often to send "still alive" signal | | 5 | Movement Start Upload | 10 (meters), 0.1 (minutes) | Distance or time before waking | | 6 | Sleep Mode | 0=Off, 1=Light, 2=Deep | Power saving strategy | | 7 | Geofence 1 | Lat/Lng + Radius | Fence center and radius in meters | | 8 | Time Zone | -5, 0, +8 | Offset from UTC | | 9 | Ignition Detection | 0=Disable, 1=Digital, 2=ACC | How to detect engine ON/OFF | A useful feature for a GPS Tracker Parameter