E07-m1101d Pinout

The EBYTE E07-M1101D is a low-power, 433MHz wireless transceiver module based on the Texas Instruments CC1101 chip. It typically features an 8-pin DIP (Dual In-line Package) header with a 2.54mm pitch. Pinout Definition

Understanding the e07-m1101d Pinout: A Comprehensive Guide e07-m1101d pinout

• Power Pins: VCC (power supply), GND (ground), and possibly VDD (voltage regulator)
• Input/Output Pins: GPIO (general-purpose input/output), data lines, address lines, and control signals
• Specialized Pins: Clock, reset, and interrupt pins

Antenna: Always screw on or solder the antenna before powering the module. Powering the module without an antenna can damage the RF power amplifier.

| Module Pin | Connect to MCU | Note | |------------|----------------------------------------|-----------------------------| | 3.3V | 3.3 V output (LDO) | Max 3.6 V, never 5 V | | GND (2) | GND | Common ground | | RST (4) | GPIO | Optional – pull-up resistor| | SCK (5) | SPI SCK | | | MISO (6) | SPI MISO | | | MOSI (7) | SPI MOSI | | | NSS (8) | SPI CS (GPIO) | Active low | | BUSY (9) | GPIO (input, interrupt capable) | Mandatory | | DIO0 (10) | GPIO with interrupt | Optional but recommended | | DIO1 (11) | GPIO (or leave NC) | Optional | | NC (12) | No connect (or GND if specified) | | The EBYTE E07-M1101D is a low-power, 433MHz wireless

Recommendations for Developers

• Add RTS ↔ CTS and CTS ↔ RTS appropriately per device’s wiring.