Decastar 150e Manual |best| May 2026

Deca Decastar 150E is a versatile MIG/MAG welding machine designed for both "NO GAS" (flux-cored wire) and "GAS" (solid wire with shielding gas) applications. www.powerparts.it Key Features of the Decastar 150E Based on the Deca General Catalog , the machine includes the following core features: Dual Welding Modes : It supports both (using self-shielded flux-cored wire) and

Conclusion

Chapter 9: Maintenance Best Practices (Extracted from Manual)

To extend the life of your Decastar 150e, the manual recommends: decastar 150e manual

The Decastar 150E is a 230V single-phase machine capable of delivering a welding current from 30A to 145A. Input Voltage: 230V. Welding Current Range: 30 – 145 Amps. Duty Cycle: 35% at maximum amperage. Weight: Approximately 30 kg. Power Consumption: 1.7 kW. Operational Modes Deca Decastar 150E is a versatile MIG/MAG welding

The machine typically has 4 "heat" positions (1-2 and Min/Max) to set voltage, while the knob on the front controls amperage by adjusting the wire speed. If switching to flux-core (gasless) wire, you must reverse the polarity Enter the Technician Menu : Press PRG for

8. Contact for Original Documentation

To obtain the original DecaStar 150E Operator’s Manual, contact the manufacturer (formerly NISSHO or current rights holder) or your local distributor. Provide the serial number located at the rear panel. Do not rely solely on this summary for first operation.

Calibration Procedure:

  1. Enter the Technician Menu: Press PRG for 5 seconds, then enter the password.
  2. Navigate to C.AL (Calibration submenu) using the arrow key, then press PRG.
  3. Select C.IN (Initial calibration – zero point). Ensure scale is empty, then press PRG. Wait for "----" and then "00000".
  4. Select C.AL again, then C.LO (Load calibration). Apply the test weight. Enter the weight value (e.g., 25.000 kg) using the arrow keys and PRG.
  5. Confirm – the indicator will display the applied weight. Remove the test weight.
  6. Save and exit. The display should now read zero.