Cobra 3195 Alarm Manual Full __exclusive__ [ iPad ]
The Cobra 3195 is a vehicle security system, part of the modular 3100 series (similar to the Cobra 3198). It features perimetric protection (doors, hood, trunk), volumetric ultrasonic interior sensors, and an engine immobilizer. Core Operations
: Press the "Unlock" button on your vehicle's original remote. The hazard lights will flash twice, and the LED will stop flashing. Passive Arming cobra 3195 alarm manual full
Conclusion
7. Common Troubleshooting
| Symptom | Likely Cause | Fix |
|---------|--------------|-----|
| “TAMPER” flashing | Sensor tamper switch triggered (cover opened). | Re‑close sensor housing, ensure no dust/obstruction. |
| False motion alarms | PIR detecting pet or sunlight. | Adjust sensitivity (MENU → SETUP → MOTION SENS) or relocate sensor. |
| No SMS alerts | GSM module not registered or SIM missing. | Insert a valid, activated SIM with SMS plan; check signal strength (MENU → STATUS → GSM). |
| Battery low warning | One or more sensors report < 2 V. | Replace the sensor battery (CR123A). |
| Unit won’t arm | Open door/contact still open. | Verify all doors/ windows are closed; run a sensor test to locate the fault. |
| System resets after power loss | Backup battery dead. | Replace the internal 12 V backup (service‑only). | The Cobra 3195 is a vehicle security system,
Disarm the system and turn the ignition ON/OFF 3 times within 7 seconds. The LED will flash to signal programming mode. The hazard lights will flash twice, and the
6. Communication Options
| Option | How It Works | Typical Use | |--------|--------------|-------------| | GSM (cellular) | Built‑in 4G modem sends SMS/voice alerts to pre‑programmed numbers. | Primary alert path where internet is unreliable. | | Wi‑Fi (TCP/UDP) | Connects to your home router; pushes alerts to the Cobra Cloud app or third‑party services (IFTTT, Home Assistant). | Low‑cost, high‑speed alerts. | | RF Repeater | Optional external repeater to extend sensor range up to 300 m (line‑of‑sight). | Large properties, outbuildings. |
Method B: Using the Ignition Key (Programmable Code) If no physical override key is installed, a PIN code is usually programmed by the installer.